![]() It ends up using the modem on the Mac, communicating over Ethernet. Run Xastir and configure it to use a KISS Serial TNC on port /tmp/port.On the Raspberry Pi, we run an instance of socat that will create a virtual serial port that forwards any data in and out into a TCP connection back to Dire Wolf.The radio interface (2x USB) is connected to the Mac.Here’s the situation that we’re going to set up. Indeed, the APRS program Xastir assumes that if you’re using a KISS TNC it’s serial. Normally TNCs in KISS mode work over a serial port. What about transmitting? Well, we see from the console output that it supports the KISS protocol and it’s listening on port 8001. MIC-E, TRUCK, Unknown manufacturer, In Service System types in the destination field will not be decoded.ĭigipeater VK7RTC audio level = 200(132/127) |||||||_ ĭigipeater WIDE2 (probably VK7RTC) audio level = 200(121/129) |||||||_Īudio input level is too high. ![]() Ready to accept KISS TCP client application 0 on port 8001. Ready to accept AGW client application 0 on port 8000. Provided the audio levels are within acceptable bounds, Dire Wolf will start showing decoded packets automatically:Ĭhannel 0: 1200 baud, AFSK 1200 & 2200 Hz, E+, 44100 sample rate. Provided you are editing nf in the same directory it should pick up the new configuration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |